Product description:

A promise to adjust illustrates, belongs to the automotive parts, including gear plate, fixed tooth plate, eccentric block, anti-backlash block, retaining ring, spring, shaft sleeve, closed loop and cone shell, campaign toothed plate in the middle of the first shaft hole, side set the first concave cavity, the first concave cavity on the ring gear, the eccentric block, there are links to the other side convex; In the middle of the fixed tooth plate, there is a second axle hole and an inner ring on one side; The axis of eccentric block has eccentric hole, and the outer circumference has the first block, ear and eccentric circle. The clearance block is waist-shaped, with a second side at one end and a groove on the other end. In the middle of the baffle, there is a baffle hole, and a second baffle is arranged on the outer circle. The card spring has a card spring foot; In the middle of the shaft sleeve, the third axle hole and the outer ring are the first, the second axle shoulder and the cover plate; The closed ring is enclosed in the movable movable tooth plate and the fixed tooth plate. The cone shell is set on the axle sleeve for axial orientation, simple structure, small size, low cost, small clearance, no displacement Angle, reliable lock and high strength.

3D renderings:

Introduction to product structure:

The electric core is neck and neck.

1. The structure of the electric modulator.

2. Installation mode of the electric core part: the shaft shall be tapered on both sides of the core piece.

3. Lower connection plate welding.

D66-16 electric modulator welding requirements: in the welding process, the inner ring area needs to be protected to prevent the welding heat and splash melt the plastic core shaft and melt the white cover, thus affecting the adjustable Angle device.

4. Welding method and appearance.

The yellow area is shown as the welding area (form 1)

The yellow area is shown as the welding area (form 2)

5. Welding positioning

The tuner USES two of the convex points and the middle hole position.                                                        

6. Board welding.

D66-16 electric modulator welding requirements: in the welding process, the inner region of the ring needs to be protected to prevent the splattering of the plastic core shaft and splashing into the core of the regulator, thus resulting in the failure of function.

7. Welding method and appearance.

Six points and welding (if the welding strength can't meet, can consider to welding) form (1) to prevent welding produce excess welding thermal radiation, which leads to a series of micro amount of welding thermal deformation of parts function problem.

4 points and half moon welding (if the welding strength cannot be satisfied, then the surfacing welding can be considered) (form 2)

8. Welding parameters

Recommended welding parameters

Welding method: CO2 gas shielded welding.

Diameter of wire: 1.0mm.

Welding current: 130~150A.

Welding voltage: 17~19V.

Air flow: 15~18L/min.

Dry extension length :10mm.

Welding speed: 7~10mm/s.